Loading
Indicative planning figures for education only — not a quotation, BOQ or structural design. Actual cement, steel and cost depend on design, soil, finish level and local rates. Verify with your architect/engineer and local suppliers.
Steel demand for a house is usually asked in kilograms of TMT for the framed structure. Varnarc’s kg-per-sq-ft factor is a planning thumb-rule for early budgeting — bar bending schedules from structural drawings will differ.
A 1000 sq ft built-up footprint is common for compact 1–2 BHK independent houses. Planning quantities assume efficient layouts; duplex or heavy projection designs can raise cement and steel intensity.
Steel for a 1000 sq ft house is a frequent early question when comparing contractor lumpsum quotes against TMT rate-per-kg markets.
Indicative planning figures for education only — not a quotation, BOQ or structural design. Actual cement, steel and cost depend on design, soil, finish level and local rates. Verify with your architect/engineer and local suppliers.
Indicative steel
4,500 kg
| Built-up area | 1,000 sq ft |
|---|---|
| Property type | Independent house |
| Floors (default) | 2 |
| Quality (default) | standard |
| Location model | National baseline (default multiplier) |
| Steel factor | 4.5 kg per sq ft (standard), scaled by quality |
Area is fixed for this landing (1,000 sq ft). Adjust quality and floors — same validated logic as the published figure.
Indicative steel
4,500 kg
basic
4,140 kg
standard
4,500 kg
premium
4,860 kg
Worked example: 1000 sq ft × 4.5 kg/sq ft × quality factor 1 ≈ 4,500 kg. Replace with BBS totals once structural drawings exist.
House-level cement and steel figures use Varnarc’s published planning quantities per sq ft (standard quality), scaled by quality factors. Construction-cost figures run the same cost engine as the interactive cost calculator for an independent house with documented defaults. Pages are published only from a curated topic×area allowlist — we do not generate combinatorial keyword URLs.
Landing 2026.08.1 · Cost engine 2026.08.1
No. It is an indicative planning estimate for education. Design, soil, finish and local rates change the final number — verify with professionals and dealers.
We only index curated topic×area pairs with unique editorial notes and validated calculation logic. We do not generate thousands of combinatorial keyword pages.
Yes — use the interactive controls on this page or open the full calculator. Defaults are documented in the assumptions list.
The kg figure is a planning total for reinforcement steel. Binding wire, chairs and cutting wastage should be confirmed with the fabricator or BBS.